Cleaning By The End User; Ordering Replacement Parts - EINHELL LK 75 Bedienungsanleitung

Anleitung LK_75_SPK1:_
GB
a) Setting of a low fan speed
→ Switches off after approx. 1 hour
b) Setting of a medium fan speed
→ Low fan speed → Switches off after approx. 2
hours
c) Setting of a high fan speed
→ Medium fan speed → low fan speed
→ Switches off after approx. 3 hours
"SWING" function key (24) – This automatically
swings the vertical air outlet fins up and down at
an angle of 70° degrees. The horizontal air outlet
fins can be manually adjusted.
"COOL" function key (25) – This is for saturating
the rotating mat behind the air intake filter with
water. The air which is suctioned in is blown out
cooler and with a higher air humidity than when it
was suctioned in. The cooler the water in the
water tank, the cooler the air which is blown out.
"NEGATIVE ION" function key (26) – This is for
switching the ionization process on and off.
All modes and functions can also be set using the
supplied remote control (with a range of approx. 5
m).
The remote control requires two MICRO (AAA) bat-
teries (not supplied). Make sure that the poles are not
reversed when you insert the batteries. Both batteries
should be new and of the same make. Please dis-
pose of your old batteries in accordance with regula-
tions by bringing them to designated public drop-off
points.

6. Cleaning by the end user

To avoid an electric shock or risk of fire, always pull
out the mains plug first before starting any cleaning
work .
A) Emptying and cleaning the water tank
The water tank should be cleaned at least every 2
weeks. To empty the water tank, remove the plug
(Fig. 5/Item 31) on the underside of the device. Allow
the water to drain into a suitable container. Clean the
tank with soap suds and then allow it to dry. Make
sure that you then replace the plug in the underside
of the device.
12
Downloaded from www.Manualslib.com
26.04.2007 14:13 Uhr
manuals search engine
Seite 12
B) Cleaning the air filter
The device is equipped with a filter (Fig. 2/Item 12).
This should be cleaned at least once a month.
Important: Never use the device without air filters.
Use a vacuum cleaner or tap the dust filter gently to
remove the dust. If the filter is very dirty, wash it care-
fully with warm water. Then allow to dry thoroughly
and fasten to the device when dry. To remove or fas-
ten the filter, the two screws have to be
unscrewed/screwed in and the filter fitted in the
guides.
C) Cleaning the housing
Use only gentle cleaner and a soft cloth to clean the
housing. Never use aggressive media, petrol, alcohol
or thinner.

7. Ordering replacement parts

Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info