Ravanson KR-1011 Original Bedienungsanleitung Seite 13

(Fig. 2)
PLEASE NOTE!
Do not exceed the "MAX" level while filling the tank.
To empty the tank
To empty the tank, slide it out, disassemble the water pump, remove the tank and empty it. Put the tank in
place, having installed the water pump before.
To disassemble the water pump, turn pump locks (fig. 3) until the pump is released and slide it out from its
location.
PLEASE NOTE! Do not pull the pump. It must stay in the device.
(Fig. 3)
To clean the filters
Air filter is located at the back wall of the device. To clean it, you should:
Press filter clips and remove the filter by pulling it forwards.
KR-1011; KR-2011
PLEASE NOTE! The filters protect the device against major pollutants.
Water filter (draining unit)