Ravanson KR-1011 Original Bedienungsanleitung Seite 12

1-2-3- switching on the climator unit fan (1, 2, 3 – fan speed)
0 – fan switched off
SWING – switching on/off the blow oscillation function
HUMIDIFER – switching on/off water pump circulating the water in the tank (see Designation)
PLEASE NOTE!
Do not use the HUMIDIFER function if there is no water in the tank.
1 – Fan ON switch.
After switching on, the fan operates with the lowest speed.
TIMER – Setting the climator unit operating time.
It is possible to set the climator unit operating time from 0.5 h to 4 h. Press the button once to
increase the operating time by 0.5 h. The set operating time is signaled by a specific combination of
control lights above the button. To resign from the operating time setting, press TIMER button until no
control light is lit above the button. The climator unit will go to the continuous operation mode.
SWING – switching on/off the blow oscillation function
ANION – switching on/off air ionization function
SPEED – setting fan speed (H – highest, M – medium; L – lowest)
WIND TYPE – the button is used for selecting air circulation: "Normal wind", "Natural wind" and "Sleeping
wind" (soothing air at nighttime).
COOL – switching on/off water pump circulating the water in the tank (see Designation)
PLEASE NOTE!
Do not use the COOL function if there is no water in the tank.
PLEASE NOTE!
While operating in a selected circulation mode, the fan increases or decreases its speed, and it can even
switch off entirely which is perfectly correct.
PLEASE NOTE!
The described functions refer also to the remote control.
Filling up water
PLEASE NOTE!
Unplug the device before you fill up water.
To fill the tank with water:
Turn the tank lock (fig. 2), remove the tank, fill up water, put the tank in place and safeguard against accidental
sliding out.
KR-1011
KR-2011