Operation - Makita SG1251 Bedienungsanleitung

Adjusting the groove width (the distance
between the two diamond wheels)
Adjust the grooving width by changing the number of
the space rings as shown in the table.
Groove width: 30 mm
Groove width: 24 mm
Groove width: 18 mm
Groove width: 12 mm
Groove width: 6 mm
1. Lock nut
2. Diamond wheel
3. Space ring 6 (6 mm thick)
4. Space ring 3 (3 mm thick)
5. Diamond wheel
004503
Installing the diamond wheels
Fig.8
Mount the diamond wheel carefully onto the spindle. Align the
directions of the arrow on the diamond wheel and the tool.
Install space rings, the other diamond wheel and the lock nut.
Tighten the lock nut securely clockwise with the lock nut
wrench while pressing the shaft lock.
Fig.9
Return the blade case and tool base to the original
position and tighten the bolt to secure them.
Adjusting the front handle angle
Fig.10
Loosen the two bolts on both sides of the front handle
with the hex wrench. Move the front handle to your
desired angle and tighten the two bolts firmly.
Downloaded from www.Manualslib.com
Groove width: 27 mm
1
2
3
4
5
Groove width: 21 mm
Groove width: 15 mm
Groove width: 9 mm
manuals search engine
NOTE:
When the handle cannot be moved easily, loosen
•
the bolts furthermore.
Shifting the front handle sideways
2
1
1. Bolt (Short)
2. Cam
3. Bolt (Long)
015043
Remove the two bolts on both sides of the front handle
with the hex wrench. Change the position of the cam.
Insert the longer bolt to the side close to the cam and
the shorter one to the opposite side. Tighten the two
bolts firmly.
Connecting to vacuum cleaner
Fig.11
When using Makita dust collector, connect the hose for
the vacuum cleaner directly to the dust nozzle.
NOTE:
The dust nozzle can be rotated freely so that you
•
can use it at any angle according to your operation.
Hex wrench storage
Fig.12
When not in use, store the hex wrench to keep it from
being lost.

OPERATION

CAUTION:
Be sure to pull the tool when cutting a workpiece.
•
Use this tool for straight line cutting only. Cutting
•
curves can cause stress cracks or fragmentation
of the diamond wheels resulting in possible injury
to persons in the vicinity.
After operation, always switch off the tool and wait
•
until the diamond wheels come to a complete stop
before putting the tool down.
Hold the tool firmly with one hand on the switch
•
handle and the other hand on the front grip when
performing the tool.
Fig.13
Hold the tool firmly with both hands. First keep the
diamond wheels without making any contact with a
workpiece. Then turn the tool on and wait until the
diamond wheels attain full speed.
7
1
2
3