Mono Mode - Kruger & Matz KMPM1 Bedienungsanleitung

PAIRING
1. Remove the earphones from the charging case. The
earphones will pair with each other within 3 seconds.
2. The right earphone will start to glow red and green,
indicating pairing mode with external device.
3. The left earphone will flash green. After successful pairing
with right earphone, LED will stop flashing.
4. Enable the Bluetooth function on the external device and
search for new Bluetooth devices.
5. Select and connect with this device (KM M1).
6. After successful pairing, LEDs will stop glowing and the
voice command will say "Connected".
Note:
• If there is no connection within 5 minutes, the device will turn off.
• Distance between the earphones should not exceed 3 meters.

MONO MODE

• To use left and right earphones separately take out one of
the earphones from the charging box (leaving one in the
charging box) and turn off the earphone. Touch and hold
the touch panel until "Pairing mode" is heard. On the
external device select and connect with the earphone.
• To reconnect the earphones, put them in charging case. Touch
and hold the touch panel for 6 seconds until the LED flashes
green three times. Take out the earphones form the charging
case.
TOUCH PANEL FUNCTIONS
• Touch once to play or pause music.
• Touch twice quickly during listening to music, to go to next track.
• Touch three times quickly during listening to music, to go to
previous track.
• Touch once, to answer incoming call.
• Touch and hold to reject incoming call.
• Touch and hold for two seconds to activate voice assistant.