Technical Data; Safety Rules - Einhell Global ABH-G 24 Bedienungsanleitung

Anleitung ABH-G 24 18.11.2003
1. Layout (Fig. 1)
1 Dust guard
2 Locking sleeve
3 On/Off switch
4 Additional handle
5 Battery capacity indicator
6 Drilling depth stop
7 Hammer stop
8 Reverse facility
9 Pushlock button for removable battery pack

2. Technical data

Voltage supply
Speed 0-1000 rpm
Hammer rate:
Drilling capacity (max.): Concrete/Stone 20 mm
Forward and reverse rotation
Battery charging voltage
Battery charging current
Mains voltage for charger 230 V ~ 50 Hz
Weight:
Vibration:
Sound pressure level:
Sound power level:
Protection class:
The noise and vibrations from this tool were
measured in accordance with EN 50144-2-6. This
hammer drill is not intended for use outdoors as
defined in Article 3 of the Directive 2000/14/EC.

3. Safety rules

Important! When using electric tools it is essential
that you comply with the following basic safety rules
for the prevention of electrical shock and risk of injury
or fire.
Please read these directions for use carefully before
you start to use this tool, and put all the information
into practice.
Check that your mains voltage is the same as
that marked on the rating plate.
If you use a cable reel, run all the cable off the
reel. The minimum conductor cross section used
should be 1.5 mm .
2
If you use this electric hammer drill outdoors you
must connect it using a suitable H07RN-F 3G
7:30 Uhr Seite 7
1.5 mm extension cable with a spray-water
2
protected plug.
Make sure of your footing, particularly when
working free-handed on ladders or scaffolding.
Use a detector to localize pipes and/or cables in
walls with concealed electric, water or gas lines.
Avoid any contact with conducting electrical parts
or lines.
Wear ear-muffs to protect your hearing: Risk of
progressive loss of hearing!
Wear goggles and use a breathing mask on
dusty jobs.
Never use the machine near vapors or
combustible liquids.
24 V =
Always unplug the machine before cleaning it or
changing drill bits etc.
Keep the power cable safe from damage. Oil and
4400 min
acids can damage cables.
Never overload the machine.
Important!
yes
Follow all safety regulations in your country appli
24 V =
cable to the installation, use and maintenance of
the machine.
2,4 A
Drill bits may be catapulted by accident out of the
tool and cause serious injuries:
- Before you begin your work, always check that
4,0 kg
the drill bit is locked in the chuck.
3,29 m/s
2
- Examine the chuck regularly for signs of wear
or damage.
83 dB(A)
- Never start a tool with hammer action until it is
94 dB(A)
pressed against the workpiece (wall, ceiling,
® / II etc.).
- Take the drill bit out of the chuck when you
have finished your work.
- Always take the battery pack out of the hammer
drill before you change the drill bit.
Always check that the chisel bit or drill bit is firmly
locked in the chuck before you start work.
Check the chuck for wear or damage at regular
intervals.
Do not start a hammering tool until it is pressed
against a workpiece (wall, ceiling, etc.).
Always unplug the hammer drill when you have
finished working and remove the chisel bit or drill
bit from the tool.
Always unplug the machine before changing
chisel bits or drill bits etc.
Protect eyes and assistants from small flying
parts and splinters. Wear a helmet! Erect a
screen wall!
Use workgloves to protect fingers from crushing
and skin from grazing.
Vibrations can be harmful to the hand-arm
system: Keep the impact time of vibrations to a
minimum.
GB
7