Klarstein 10028594 Handbuch Seite 6

Assembling the Meat Grinder
• Step 1
Take the body (Cutter housing 22) by the feed tube with the largest opening upwards.
Insert the worm shaft (16) with the drive pins first in the cutter housing (22). Fit the
cutter blade (17) on the shaft with the cutting edges upwards.
• Step 2
Place the selected hole-plate (14, 15, 18) over the blades ensuring that the two lugs fit in
the two cut-outs in the body. Screw ring (19) the cap nut fully home on the body. Check
the assembly.the shaft should have no play nor be able to turn on itself.
• Step 3
Play the multifunction head in the horizontal position (a click should be heard ). Offer up
the assembled mincer attachment, titled towards you, to the outlet and engage it fully
(figure 1). Return the feed tube to a vertical position by turning to the rear until it stops
(figure 2). Place the removable tray on the feed tube (figure 2).
Assembling the Sausage Accessory
• Sausage canister
Insert the worm shaft (16) with the drive pins first in the cutter housing
(22). Fit the cutter blade meat spreader (23) and sausage canister (24)
on the shaft with the cutting edges upwards, then fit the screw ring
(19) onto the cut housing (22), turn clockwise to lock. The ring nut must
hold the sausage canister securely in place. But do not over tighten.
• Cone
Fit the separator (26) and the Cone (25) on the shaft with cutting edges
uwards, then fix the screw ring onto the cut housing (22), turn clock-
wise to lock. The ring nut must hold the sausage canister securely in
place. But do not over tighten.
How to Use the Accessory
6