Symbols On The Device; Description Of The Device; Installation; Initial Startup - Kärcher MT 36 Bp Originalbetriebsanleitung

event of any shipping damage, please notify your deal-
er.

Symbols on the device

General warning symbol
Read the operating instructions and all
safety instructions before operating the
device for the first time.
Do not subject the device to rain or moist
conditions.
Pull: Quick-release catch

Description of the device

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
See graphics page for illustrations
Illustration A
Clamping screw
1
Lock
2
Shaft
3
Front handle
4
Trigger lockout button
5
Speed switch
6
Trigger
7
Rear handle
8
Battery pack unlocking button
9
Eyelet for carrying belt
10
Type plate
11
*Battery Pack Battery Power 36V
12
*Quick Charger Battery Power 36V
13
Carrying belt
14
* optional
Rechargeable battery pack
The device can be operated with a 36 V Kärcher Bat-
tery Power+ battery pack.

Installation

Installing the front handle
1. Screw the front handle to the shaft at the desired po-
sition.
Illustration B
20
Installing accessories
ATTENTION
Dirt at the joints
Damage to the device if dirt gets between the connec-
tion points during assembly.
Check the joints for contamination and remove before
assembly.
Only lay dismantled connecting parts on clean surfaces.
1. Plug in the accessories
Illustration C
a Loosen the clamping screw.
b Pull out the lock.
c Insert the shaft of the accessory.
2. Allow the lock to latch into place. Make sure that the
lock is securely positioned in the hole of the inserted
shaft.
3. Tighten the clamping screw.
Installing the battery pack
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
Illustration D
Hooking the carrying belt
The carrying belt helps to lower the device in a con-
trolled manner after cutting and to catch the weight of
the device during use.
1. Fit the hook of the carrying belt into the eyelet on the
shaft.
Illustration E
2. Place the carrying belt over one shoulder. Make
sure that the carrying belt can be released quickly in
the event of danger.
Switching on the device
1. Flip the trigger lockout button to the rear.
Illustration F
2. Press the trigger.
The device starts up.
3. Release the trigger.
The device stops.
1. Use the Speed switch to select the desired speed.
Illustration G
Removing the battery pack
Note
During longer work breaks, remove the battery pack
from the device and secure it against unauthorised use.
1. Pull the battery pack unlocking button in the direc-
tion of the battery pack.
Illustration H
2. Press the battery pack unlocking button to unlock
the battery pack.
3. Remove the battery pack from the device.
Finishing operation
1. Remove the battery pack from the device (see
Chapter Removing the battery pack).
2. Clean the device (see Chapter Cleaning the de-
vice).
English

Initial startup

Operation

Setting the speed