Troubleshooting - Pattfield E-ARM 3440 Li Bedienungsanleitung

Troubleshooting

Caution! Make sure the appliance is switched off and the batteries are removed. Al-
ways wear protective gloves.
Problem
Motor does not
run
Motor power
drops
Collection bag is
not filled suitably
If the device still does not work, please contact your local HORNBACH store or write an email
to: service@hornbach.com
122 EN
Possible cause
Battery empty
Unsuitable cutting areas
Blade is blocked
Battery is not inserted correctly
Release key is not inserted
correctly
Wrong cutting height
Wrong cutting height
Discharge chute is blocked
Poor and uneven cut
Unsuitable cutting areas
Poor and uneven cut
Collection bag is full
Discharge chute is blocked
Solution
Recharge battery
Start on short or already mown grass.
Clean discharge chute and housing
(blade must rotate freely)
Remove batteries and insert again
Re-insert key and push it to the right
while lifting the on/ off trigger
Set the wheels to the correct cutting
height
Set the wheels to the correct cutting
height
Clean discharge chute and housing
(blade must rotate freely)
Replace the blade (contact service)
Set the wheels to the correct cutting
height
Allow lawn to dry
Replace the blade (contact service)
Empty the collection bag
Clean discharge chute and housing
(blade must rotate freely)