General Description - Gewiss Chorus GW 90 769 Bedienungsanleitung

The wind sensor is used for the transformation of wind force into electrical signals. These
signals are generated by a Reed contact, that closes under the effect of magnets. A shaft
mounted on slide bearings is fixed to rotating pallets and moves the magnet near to the
Reed contact.
The device generates a sequence of frequency impulses according to the wind
speed. The GW 90 769 wind sensor is used in combination with the GW 90 770
wind sensor interface.

GENERAL DESCRIPTION

Functions
Cable length: 3 m
Fastening
plate
Magnet
Output cables
6
Reed
contact