i-tec ADUANCE-Serie Gebrauchsanweisung Seite 8

i-tec AA/AAA/9V Battery Charger 4 Channel
USE / CHARGING
Charger charges either 1-4 batteries size AA/AAA or 1-2 batteries size
Ÿ
AA/AAA and 1 battery 9V.
Plug one end of the AC cord into the charger and the other end into the
Ÿ
network. Green LEDs will blink.
Insert the rechargeable batteries into the corresponding slots and make
Ÿ
sure that they are inserted correctly (polarity "+, -").
If the batteries are inserted correctly and the charger is plugged in, the
Ÿ
corresponding LED lights up and charging is started - an adequate
charging level for AA/AAA and 9V flashes. For AA/AAA, first block lights
at 50% charging level, two blocks at 75% level and all blocks light at
100%. After charging of all charged batteries to 100%, LEDs will remain
lit and charging goes into maintenance mode (20 mA) for max. 2h.
The charger will not work and recharge, if defective or non-rechargeable
Ÿ
batteries (standard or alkaline) are inserted, or they are not inserted
correctly. In this case, no charging appears on the respective LED, it will
only flash and the charging will switch off in 1-2 minutes.
Charging time (approximate data) = Capacity [mAh] : Current [mA]
Battery type
AA Ni-MH
AA Ni-MH
AAA Ni-MH
9V Ni-MH
AA Ni-Cd
AA Ni-Cd
AAA Ni-Cd
SPECIFICATIONS
Input voltage: AC 100V-240V, 50/60Hz, 10W; DC 12V/1.5A
Ÿ
Output voltage/current: DC 1.48V/max. 500mA (1x AA = 500mA, 2x AA =
Ÿ
2x 500mA, 3-4x AA = 3-4x 500mA; 1x AAA = 1x 500mA, 2x AAA = 2x
500mA, 3-4x AAA = 3-4x 500mA), 9V/50mA
Length of AC cord: 1 m
Ÿ
Product dimensions: 128 x 75 x 31 mm
Ÿ
Product weight: 108 g
Ÿ
EN
07
Downloaded from www.Manualslib.com
Charging time
Capacity
for 1 battery
1500 mAh
2500 mAh
800 mAh
280 mAh
1000 mAh
800 mAh
300 mAh
manuals search engine
Charging time
for 2 batteries
3.6 h 3.6 h
6 h 6 h
1.92 h 1.92 h
6-7 h
2.4 h 2.4 h
1.92 h 1.92 h
0.72 h 0.72 h
Charging time for
3-4 batteries
3.6 h
6 h
1.92 h
- -
2.4 h
1.92 h
0.72 h