Medion Gopal P 4245 Bedienungsanleitung Seite 235

3. Remove Preload Only
Removes the data needed for the installation of the navigation
software from the permanent memory (\My Flash
Disk\Install).
4. Remove All
Deletes the whole contents of the 'My Flash Disk' memory. It
will not be necessary to recalibrate the screen after this func-
tion has been carried out.
5. Factoryreset
Sets the device back to the delivery status in the case of an
intact main installation.
6. Format Flash
Formats the internal 'My Flash Disk' memory. This formatting
can be necessary in the case of a prolonged removal of errors.
It will be necessary to recalibrate the screen after the format-
ting function has been carried out. All data will be deleted
from the internal 'My Flash Disk' memory irrevocably.
7. GPS Factory Reset
Performs a factory reset of the GPS receiver. When using the
GPS function after having performed a factory reset, the GPS
receiver must orientate itself again. This process may take a
while.
8. DC AutoSuspend / Wakup
You can select here when your navigation system should go
into Standby mode automatically after the withdrawal of the
external power supply. For example, this function is useful in
the case of vehicles where the cigarette lighter also switches
off when the ignition is switched off.
The AutoSuspend function will be activated several seconds
after the discontinuation of the external power supply and the
Standby display will appear for the time set (see Page 23).
Appendix 83