Switching The Device Off Completely / Hard Reset - Medion Gopal P 4245 Bedienungsanleitung

Switching the Device off Completely /
Hard Reset
Attention!
A hard reset will delete all data in the temporary mem-
ory.
Your navigation system will normally be in the Standby Mode,
if you have switched it off by pressing the on/off button
briefly. In addition, the system can be switched off completely;
the consumption of energy can be kept as low as possible
through this. All the data in the temporary memory will be lost if
the device is switched off completely (hard reset).
To switch your navigation system off completely:
1. Press and hold the On/Off key (> 3 sec.), to switch off the
device.
2. Press and hold the On/Off key (> 3 sec.), to switch the
device on again.
A reinstallation will not be necessary after a hard reset if your
device has already been equipped with the basic data of the
navigation software in the permanent memory at the factory.
Security 35