Troubleshooting - AEG ITE42600KB Benutzerinformation

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or oper-
ate the appliance.
An acoustic signal sounds
and the appliance deacti-
vates. An acoustic signal
sounds when the appliance
is deactivated.
The appliance deactivates.
Residual heat indicator does
not come on.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
The control bar blinks.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
A zone is not hot because it
operated only for a short
time
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Child Safety Device or Lock
operate.
There is no cookware on the
zone or the zone is not fully
covered.
ENGLISH
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Put large cookware on the
rear zones, if possible.
Activate the sounds.
Refer to "Daily use".
Refer to "Daily use".
Put cookware on the zone so
that it fully covers the roast-
ing zone.
17