NODOR D7008 Bedienungs- Und Wartungsanleitungen Seite 23

0
To fi nd out which model your oven is ("a",
"b") compare its control panel with the control
panels shown in the illustrations.
1
1.1 Unpacking. Remove all the protective
1.2 Mains connection. Always take into
2
Before using your new oven for the fi rst
time, heat it up while empty (with no food
in it and with the control turned to
30 minutes at 250ºC). It may produce some
smoke or a bad smell (this is normal and is
caused by the oven heating up grease residue
etc.). When it has cooled down, pre-clean it by
wiping the inside with a damp cloth.
2.1 Accessories. Depending on the model
Downloaded from www.Manualslib.com
Identifi cation
Installation
packaging elements.
account the data on the reference plate
(1.2.1) and the measurements of the
cabinet the oven will be housed in (1.2.2,
1.2.3).
The appliance must be connected to the
mains with a fi xed single-phase connection
with the neutral (blue) connection
guaranteed (1.2.4). Fit the oven into the
space, ensuring there is no excess cable
in the upper part (1.2.5, 1.2.6). Screw it to
the fi tting using the two screws supplied
(1.2.7). The fi tted furniture or its surface
must be heat-resistant. The time must be
set in order to fi nish the installation (a, c, d,
f). After a period of inactivity, the machine
will turn to standby and its brightness
will diminish or the screen will switch off,
depending on the model.
Using the oven
there is a Deep Tray (2.1.1), Flat Tray
(2.1.2) and Multifunctional Grill (2.1.3)
that work separately. If it also possible to
combine either tray with the Multifunctional
Grill (2.1.4) to make a set. All the
accessories or sets can be used directly
or mounted on the Partial Extraction Grill
(2.1.5) or the Total Extraction Grill (2.1.6,
manuals search engine
2.1.7), (2.1.8). If you have the partial
extraction tray, it can be used separately
or together with trays (3 types) (2.1.9). The
Simple Grill is used separately (2.1.10). If
you have telescopic rails, remove the tray
before installing them in the oven (2.1.11).
The telescopic rails extend automatically
due to the weight of the tray when the
oven is opened (2.1.12). Food must always
be placed on a tray on the telescopic rails
(2.1.13). Bear in mind the position of the
grills when installing them. There are anti-
tipping stops at the sides (2.1.14).
2.2 Accessory positions. The accessories
can be fi tted in 5 different positions,
2.3 Setting the time. Press the
(2.3.1). Set the time using the
buttons (2.3.2). After a few seconds
stop fl ashing (2.3.3).
Note: the time will need to be set again
after an electricity cut or when the hour
changes.
2.4 Cooking the food. Place the food in the
oven. Consult the cooking table to choose
the accessory or accessories to be used
and their position. Close the oven door.
2.5 Selecting the cooking function.
Select the cooking function according to
the model
Traditional fanned heat. For any kind
of dish. Several dishes may be cooked
at once without their fl avours or smells
mixing.
Turbo plus. The heat is produced by the
central element.
Fanned high grill. This browns the food,
, at for distributing the heat evenly. Ideal for large-
sized roasts.
High grill. For browning pasta, souffl és
and bechamel sauce.
Low grill. For hamburgers, toast and food
with a small surface area.
Fanned base heat. The fan distributes the
base heat evenly. Suitable for paellas.
Traditional heat. For bread, cakes, cakes
with fi lling and lean meat.
Defrost. Rapidly thaws any kind of food.
e n g l i s h
.
button.
,
will
21