Herunterladen Diese Seite drucken

Eaton NZM1-XSV Montageanweisung Seite 2

Werbung

Druck_IL01219038Z2011_02.fm Seite 2 Dienstag, 14. Juni 2011 10:27 10
Mounting – Montage – Montaje – Montaggio –
1
1
OFF
2
1
4
2
ON
2/3
– Монтаж
The release pin must be fitted!
Do not fit the switch without pin in the socket base!
Auslöse-Stift muss unbedingt montiert sein!
Schalter nicht ohne Stift in Stecksockel montieren!
Le poussoir de déclenchement doit être monté!
Ne pas monter le disjoncteur dans le berceau sans le poussoir!
¡La patilla de disparo debe estar montada!
¡No monte el interruptor sin patilla en el zócalo!
Il perno di sgancio deve essere necessariamente montato!
Non montare l'interruttore nello zoccolo da innesto senza il perno!
必须装有释放销钉!
如果销钉未插在插座中,不得安装开关!
Размыкающий штырёк должен быть обязательно установлен!
Не устанавливать выключатель в разъем без размыкающего штырька!
3
1
1
Emergency On Call Service: Local representative (http://www.eaton.com/moeller/aftersales) or +49 (0) 180 5 223822 (de, en)
2 x M4
1.5 Nm
(13.28 lb-in)

Werbung

loading

Diese Anleitung auch für:

+nzm1-xsvse