Installation In The Vehicle - UltraMedia MSat-65 Bedienungsanleitung

INSTALLATION IN THE VEHICLE

1. Make the cable connections within the vehicle as short as possible.
2. Position the control unit near your TV set.
Mount the control unit as horizontally as possible.
3.
The control unit should not be covered with a shielding metal housing.
4.
a) Connect the antenna cable to the corresponding input [ANTENNA
b) Connect the television / receiver with an antenna cable to the output
c)
d) Connect the incoming control cable to the connection [Motor
5. Connect the satellite receiver to the vehicle's electrical ground.
6. Connect the control unit to the secured 12 / 24V DC power supply of your
vehicle.
- 12-24 Volt DC:
- Motor contact:
- Mass (10A):
INPUT] of the control unit.
[LOOP OUT] of the control unit.
Connect the cable from the mini control unit to the [Control Panel]
connector.
Control].
Red cable
Blue cable
Black cable