FlyTek ZiP Betriebs- Und Wartungsanleitung Seite 11

The coffee delivery is located in the front of the machine
During the delivery do not touch the spout and do not expose yourself to the hot surfaces
of the appliance (danger of burning). The heating surfaces are subject to residual heat
after use!
Switch on the coffee machine by pressing the green light switch located on the left side of the appliance; the
power-on indicator light will light up. After switching on the machine, it begins the fast process of warming of the
boiler. Wait that the temperature ready-light is lighted up (Ref. C) and the coffee machine is ready to be used.
Lift the lever machine upwards (Ref. F) as shown in the figure 1 and insert as the pod as shown in the figure 2.
For the first coffee brewing: insert a pod into its insert point (Ref. H) and gently lower the lever to snap limit.
Place one espresso cup under the delivery spout and press the coffee delivery switch (Ref. D); after about 5
seconds the coffee brewing will start. Reached the desired coffee level in the cup, press again the coffee delivery
switch to stop the coffee brewing. If during the coffee brewing the temperature ready-light (Ref. C) goes off, it
simply means that the machine is warming up to bring water to the correct temperature; thus the coffee brewing
can continue. While it is advisable to wait that the temperature ready-light (Ref. C) is lighted up before brewing the
next coffee.
For all subsequent coffee brewing : proceed exactly as above.
Use only the pods of your supplier, the use of pods different from those for which the
machine has been designed can damage the appliance.
It is important to empty the water container (Ref. A) after the brewing of not more than 20 cups of coffee.
If the container is not emptied, the water can flow out.
COFFEE DELIVERY SPOUT (REF. B)
TURNING ON
HOW TO MAKE THE COFFEE
11