Werbung
Verfügbare Sprachen
Verfügbare Sprachen
X
X
N
N
E
E
T
T
N
N
e
e
NETWORK : This Ethernet terminal connects to 10Mbps or 100Mbps LAN through an RJ-45 connector.
LINK : Yellow light indicates that the network is properly connected.
ACT : Green light indicates that the XNET system is connected to 100Mbps LAN. This green lamp will
blink if the system receives data.
STATUS LED : Indicates the operation status
EVENT LED : Green light indicates that Alarm Out signal is turned on.
POWER LED : Red light indicates that 12 VDC power is connected.
RS-485 and ALARM In/Output Terminal
1
RS-485: When properly connected, you can remotely control Pan/Tilt device with RS-485 control
interface.
Alarm In: This connects to an alarm sensor signal. Only one sensor can be connected.
Alarm Out: This connects to an external alarm device that operates by a relay such as Siren
SD CARD SLOT : Enables recording of video data to an external memory device upon occurrence of an
Power Terminal: Connect 12V DC Power to this terminal.
Downloaded from
www.Manualslib.com
t
t
w
w
o
o
r
r
k
k
B
B
o
o
x
x
C
C
a
a
m
m
e
e
r
r
a
a
I
I
n
n
s
s
When optional PoE is used, the power will be supplied from the Network Cable.
Pin
1
2
3
4
5
6
6
Lamp or Alarm Light. Only one Alarm device can be connected.
event. Please use less than 4 GB SD Memory.
Do not use this connector when powering up the product through LAN
cable (PoE).
damaged by connecting both Ethernet power and 12V DC power to this
terminal.
manuals search engine
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
G
G
u
u
i
i
d
d
e
e
Description
Alarm Out
Select NC/NO at menu screen
Alarm Out
Alarm In (+)
Select NC/NO at menu screen
Alarm In (-)
RS485 +
RS485 -
Figure 2-4. SD CARD
The product is not covered under warranty when it is
Set up
8 / 17
Werbung
Kapitel
