Standby Mode; Status Bar - Liemke MERLIN-13 Bedienungsanleitung

6.2 Standby Mode

> Press and hold P button (2) until the countdown
appears, release the button within 3s countdown
to active the standby mode.
> Short press P button (2) again to exit standby
mode.

6.3 Status Bar

In the home interface, there are system information
hints at the bottom of the screen including: Palette,
Screen Brightness, Calibration mode, Battery status
etc.
6.4 Calibration
> In the home interface, short press the P button (2)
for shutter calibration.
6.5 Image Movement
> In home interface, press and hold the P button (2)
and M button (4) to enter into the image
movement interface.
> The movement distance and direction on X & Y
axis appear on the interface.
– Short press P button (2) to move upward one
pixel.
– Long press P button (2) to move upward ten
pixels.
– Press and hold P button (2) constantly to move
upward continuously.
– Press the M button (4) to move downward,
and the adjustment
> Press P button (2) and M button (4) simultaneously
to switch the movement directions.
> While switched to horizontal movement, press P
button (2) to move towards left and M button (4)
to move towards right. Movement method is same
as vertical on Y-axis.
> Long press the P button 2) and M button (4) simul-
taneously to save calibration data. Once saved,
the device will exit this interface after 2s.
TIP!
> Without button input, the device will
exit image movement interface after
30s, without saving.
MERLIN –13 · Operating Manual 07 / 2020
E
N
10
–
11