Plug & Play (Initial Setup) - Samsung 5+ Serie Bedienungsanleitung

When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Press the POWERP button. Plug & Play is available only when the Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected (p. 6).
✎
To return to the previous step, press the Red button.
1
Selecting a language Press the ▲ or ▼ button, then press the ENTERE button.
2
Selecting Store
Demo or Home Use
3
Selecting a country
(depending on the
country)
4
Setting the Clock
Mode
5
Selecting an antenna Press the ▲ or ▼ button, then press the ENTERE button. Select the Antenna
6
Selecting a channel
7
Enjoy your TV.
If You Want to Reset This Feature...
You should do Plug & Play
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0"
(except France). If you want to change the PIN number, use the Change PIN function.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to "0-0-0-0" (France: "1-1-1-1"):
Plug & Play (Initial Setup)
Select the desired OSD (On Screen Display) language.
Press the ◄ or ► button, then press the ENTERE button.
Select the Home Use mode. Store Demo mode is for retail
environments.
To return the unit's settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see the
volume OSD, press and hold
Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when you
watch at home.
Press the ▲ or ▼ button, then press the ENTERE button. Select the
appropriate country. (depending on the Country)
✎
After selecting the country in the Country menu, some models may proceed
with an additional option to setup the pin number.
✎
When you input the PIN number, "0-0-0-0" is not available.
Set the Clock Mode automatically or manually.
Auto: Select the time zone (depending on the country) where you are located.
Manual: Allows you to manually set the current date and time.
source to memorise.
Press the ▲ or ▼ button, then press the ENTERE button. Select the channel
source to memorise. When setting the antenna source to Cable, a step appears
allowing you to assign numerical values (channel frequencies) to the channels. For
more information, refer to Channel → Auto Tuning.
Press the ENTERE button.
→ System) again at home although you did in shop.
(MENU
English - 7
MENU for 5 sec.
→ 8 → 2 → 4 →
MUTE POWER
POWER
P
(on).