Hama SNAPDROP Bedienungsanleitung Seite 6

Note – Bluetooth password
• Some terminal devices require a
password in order to connect to another
Bluetooth device.
• If your terminal device requests a
password for connection to the speaker,
enter 0000.
4.4 Automatic Bluetooth connection
(after successful pairing)
• Make sure that your Bluetooth capable
terminal device is on and Bluetooth is
activated.
• Make sure that the speaker is located within
the Bluetooth range of max. 10 metres.
• Switch on the speakers as described in 4.1
Switching the product on and off.
• After successful connection, the status LED
(8) will light up in blue. An acoustic signal
confirms that connection was successful.
Note – Connection impaired
• After the speaker and terminal device
have been paired, a connection is
established automatically. If the
Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your
terminal device to see whether Hama
Snapdrop is connected. If not, repeat
the steps listed under Bluetooth pairing.
4.5 Audio playback (via Bluetooth )
Start and control audio playback on the
connected terminal device accordingly.
Alternatively, audio playback can also be
controlled on the speaker (if the connected
device supports this function).
• Press the >ІІ function button (4) to start or
pause audio playback.
• Briefly press the >> + function button (5) to
skip to the next track.
• Briefly press the << – function button (3) to
go back to the previous track.
• Hold down the >> + function button (5) to
increase the volume.
• Hold down the << – function button (3) to
reduce the volume.
5