Epson ELPIF03 Bedienungsanleitung Seite 7

Installing and Removing the Interface Board
Procedures and illustrations may di er depending on the projector you are using. For
details, see the "User's Guide" supplied with the projector.
Installing
You can install boards in Slot1 or Slot2 on the projector.
* Tighten the xing screws evenly to
prevent the interface board from
tilting.
Remove the slot cover.
A
Loosen the fixing screws (4 points) with a com-
mercially available No. 2 cross-head screwdriver,
and pull out the slot cover.
Store the removed slot cover in a safe place.
* The slot cover may not be attached depending
on the projector you are using.
Before replacing this product with another inter-
face board, make sure you remove the interface
board from the projector first.
➡ P. 8 - "Removing"
Make sure the interface board is not at an
B
angle, and insert it straight into the slot.
Push the interface board firmly into the slot until
it is fully inserted.
Tighten the xing screws (4 points) with a
C
commercially available No. 2 cross-head
screwdriver.
Tighten the xing screws securely. If the in-
•
terface board is not xed securely in place,
the projector may malfunction.
Do not use an electric screwdriver when
•
tightening the xing screws. Doing so
could damage the interface board.
Caution
中
文
简
体
中
文
繁
體
7