- EN -
Supplemental instructions for operation
• After an interruption of the power supply, the power outlets do not switch on again automatically.
• Do not connect any InScenio controllers or portable multiple sockets to the unit.
• The device is only de-energised when the plug of the mains supply cable is unplugged.
Operation
How to operate the manual transmitter:
LED
Control lamp
O
switch off
I
switch on
– +
dim
Remedy of faults
Malfunction
Unit does not respond to commands from the
hand-held transmitter
Maintenance and cleaning
Cleaning the device
Clean the unit with a soft, clean and dry cloth. Never use aggressive cleaning agents or chemical solutions. These can
attach the housing surface or impair the function.
Replacing the fuse
The unit control electronics are fused by means of a fine fuse. The fuse is located in a special fuse holder (J, 11).
Please contact your specialist dealer if you do not wish to undertake the replacement yourself.
How to replace the fuse:
• Pull the plugs of all units connected to power supply distributors.
• Isolate the power supply distributor.
• Hold the unit, then turn the fuse holder counter-clockwise by a quarter of a turn using a screw driver and exerting
light pressure (bayonet closure).
• Remove the fuse holder including fuse.
• Replace the fuse.
Use fine fuse 5 × 20 mm, 2 A slow-blow.
• Turn in the fuse holder again.
• Reconnect the unit.
8
InScenio FM-Master 1
a Switch channel 1
b Switch channel 2
c
no function
d no function
Cause
Receiver in the unit does not receive from the
manual transmitter
Interference over radio distance
Receiver in the unit defective
Battery in the hand-held transmitter is dead
(LED of the manual transmitter does not light)
Fine fuse has tripped because a unit without
dimming function was connected to channel 3 (only
InScenio FM-Master 3)
InScenio FM-Master 2
a
Switch channel 1
b
Switch channel 2
c
Switch channel 3
d
no function
Remedy
Teach-in manual transmitter
Choose a different place, ensure unob-
structed view
Contact the OASE service
Change battery
Replace fuse
Only connect units with dimming function to
channel 3.
InScenio FM-Master 3
a Switch channel 1
b Switch channel 2
c
Switch channel 3
d Dim channel 3