Maintenance And Troubleshooting; Service And Warranty; Technical Specifications - Wiha speedE Anleitung

TECHNICAL SPECIFICATIONS

Maintenance and troubleshooting

The speedE II is maintenance-free and requires no lubrication.
®
Should the speedE II no longer work, contact an authorised customer
®
service point for Wiha power tools.
Have damaged parts repaired before use.
Do not correct issues yourself!
State the article number according to the nameplate of your speedE
for all inquiries and spare part orders.
For additional information regarding the repair and maintenance of your
speedE II, exploded drawings and information about spare parts, visit:
®
www.wiha.com
Technical specifications
li-ion battery
Article number
Order no.
Rated voltage/capacity
Number of battery cells
Max. running time acc. to each
screw fastening case
speedE II
®
Torque, hard
Torque, soft
Protection class
Idling speed
* Measured value for noise determined according to EN 62841-2-2. The A-weighted sound pressure level of the power tool is typically less than 70 dB(A). Uncertainty K=3 dB. The noise level during operation can
exceed 80 dB(A). Wear ear protection! Overall oscillation values ah (sum of vectors in three directions) and uncertainty K determined according to EN 62841-2-2: screws: ah<2.5 m/s², K=1.5 m/s².
** The oscillation level and noise emission value were measured according to a standardised measuring method and can be used for comparing power tools with each other.
The value is suitable for a preliminary assessment of the oscillation load. The oscillation level and noise emission value can deviate if the power tool is used for other applications with deviating application
tools or insufficient maintenance. This can considerably increase the oscillation load throughout the entire duration of operation.
A precise assessment of the oscillation load must take into account the times in which the device is shut off or is running but not actually used. This can considerably lower the oscillation load throughout the
entire duration of operation. Set up additional safety measures to protect the user from the effect of oscillation.
For example; maintenance of the power tool and application tools, keeping hands warm, organisation of work processes.
20
®
Emissions
Sound pressure level*
599001
Oscillation level**
41914
3.7/1.5 V/Ah
1
around 400 fastenings
Length x width
0.45/1.0 Nm
(without slimBit)
0.3/0.5 Nm
Length x width (with
IP54
slimBit)
280 min - ¹
Rated voltage

Service and warranty

Loss of the nameplate voids all warranty claims!
The nameplate is found on the front lid near the LED lamp.
Customer care
Wiha Werkzeuge GmbH
II
Obertalstrasse 3–7
78136 Schonach
GERMANY
< 70 dB(A)
< 2.5 m/s²
147 x 39 mm
202 x 39 mm
3.6 V
Tel.: +49 77-22 959-0
Fax: +49 77-22 959-160
Email: info.de@wiha.com
Website: www.wiha.com
Charger
Article number 599002
Order no. 41915
Charging time 75 min
Protection rating 2
Mains voltage 100–240 V
Weight (without li-ion 177 g
battery and slimBit)
Weight (with li-ion
battery) 212 g
EN