Inhaltsverzeichnis
Werbung
Do throw batteries into fire or water. Risk of explosion.
Should you find any battery defects, please do not replace these yourself but rather contact our customer service team.
Correct maintenance and winter storage of the device
Fully charge the battery after the final use of the year (see pages 118 and 119) and then disconnect it from the power supply (F).
Store the product in a dry room with an ambient temperature of 9–20°C.
The battery will gradually lose its charge while idle, so it should be recharged approximately every 3 months. This prevents a
deep discharge (complete discharge of a battery). This type of deep discharge damages your battery, and in the worst case,
could cause the battery to stop functioning altogether.
In order to protect the battery against a self-discharge, the awning drive will switch to hibernation mode following an inactivi-
ty period of 2 weeks. Hibernation mode can also be manually activated (see page 21). Fully charge the awning drive before
activating hibernation mode.
Note on the solar panel
The solar panel serves as an auxiliary charging unit for the battery installed in the product.
Note: In the event of a low energy yield (e.g. thick clouds over a long period), it may be necessary to charge the battery using
the included charging unit.
With a sufficient energy yield, the solar panel can compensate for one drive cycle per day.
Install the solar panel in a clear, sunny location to enable the greatest possible energy yield.
Note: Strong heat development can lead to a reduced energy yield.
Regularly clean any dirt away from the solar panel using a damp cloth and a suitable cleaning agent.
Recommendation: Disassemble the solar panel in winter and store it in a dry place after cleaning.
Damage to the glass surface, frame edge, cables and plugs could make the solar panel unusable.
You must only plug either the solar panel OR the charger into the product. Simultaneous use, e.g. via an adapter, is not permit-
ted and could cause the product to become unusable.
INTENDED USE
The product is exclusively intended for use on properly constructed hinged arm awnings with a stepped crank mechanism.
The awning systems must be in perfect condition.
The awning systems must be easy to operate with the crank handle.
Defects in the awning systems must be remedied and damaged parts replaced before using the product.
Any other use or additional usage of the product is considered to be improper use.
The operation field of the hand release must be installed at a height below 1.80 m.
The product should only be operated with the wireless transmitters approved by Schellenberg.
Alfred Schellenberg GmbH is not liable for personal, material or consequential damage in the case of improper use.
IMPORTANT INFORMATION ON PROGRAMMING, OPERATION
When both buttons are pressed simultaneously (when programming and/or deleting the end positions), the LED flashes for
10 seconds. The next action must take place within these 10 seconds.
A programmed path can be stopped prematurely at any time using the opposite button.
The end positions must be configured before connecting the approved wireless transmitters.
If the end positions have not been set, the drive unit can be moved manually over the end positions of the awning.
EU DECLARATION OF CONFORMITY
The MarkiDrive Premium (item no.
mity has been demonstrated. The full EU Declaration of Conformity document can be found at: http://www.schellenberg.de (under
'Download-Center', in the 'Service' tab).
Machinery Directive 2006/42/EC
Radio Equipment Directive (RED) 2014/53/EU
RoHS Directive 2011/65/EU
20264) meets the applicable requirements of European and national regulations. Confor-
11
GB
Werbung
Inhaltsverzeichnis
