Use; Using The String Of Lights; Changing Bulbs - Melinera Z28965 Bedienungs- Und Sicherheitshinweise

The string of lights is protected against splashes of water (IP44) as
1
long as the socket meets the minimum protection standard.
If in any doubt about the safe installation or use of this product, please
consult a qualified electrician.
Make sure the string of lights
mowers, trimmers, scissors or similar cutting tools are used.
Only use the string of lights

Use

Using the string of lights

CAUTION! The bulbs can become loose during transport. Make sure
7
before starting that all the bulbs
First fit the decoration on the bulbs
2
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs may otherwise be damaged.
7
Insert the supply line plug into the socket of the power pack
the cap nut in clockwise direction.
Push the ground spikes into a suitable surface (lawn, etc.).
Note: Arrange the decorative lights so that the distance between each
ground stake is at least 1.5 m.
Plug the power pack into a suitable socket. The lights are switched on.
3
To switch the lights off, remove the power pack
8 GB
74291_Z28965-Z28966_VDE_mel_LED_Gartenleuchtstaebe_Content_LB4.indd 8
is not laid down in areas where lawn
1
if all fittings are equipped with bulbs
1 6
are properly in the fittings .
7 6
(see Fig. A).
7
. Tighten
3
from the socket.
3

Changing bulbs

DANGER TO LIFE BY ELECTRIC SHOCK! Always
unplug the power pack from the socket before installation, dismantling,
3
maintenance or cleaning.
CAUTION! RISK OF BURNS! Allow the string of lights
. down completely before changing the bulbs
7
First lift the decoration
2
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs may otherwise be damaged.
7
Remove the faulty bulb
7
(see Fig. B).
Plug a new bulb into the fitting
4
CAUTION! Make sure that the type, operating voltage and wattage
are correct. Never use other than the stated bulbs
CAUTION! The bulbs
7
in. This can cause damage.
Note: the bulb will only light up if it is fitted the right way round.
7
The marks on the bulb
7
another (see Fig. B). Remove the bulb
replace it in the opposite direction.
Note: make sure that the wires are pointing upwards and that there is
no foreign matter in the fitting
Replace the decoration
2
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs may otherwise be damaged.
7
to cool
1
.
7
up and off the bulbs (see Fig. A).
7
from the fitting by bulb remover
6
.
6
.
7
have a plug-in system. Never screw the bulbs
and the fitting have to be in line with one
6
if it does not light up and
7
.
6
over the bulb (see Fig. A).
7
5
7
22.05.12 12:33