Inhaltsverzeichnis
Werbung
20
Downloaded from
www.Manualslib.com
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 19)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 20)
(4-pin CHA_FAN2)
(see p.1, No. 7)
CPU Fan Connector
FAN_VOLTAGE_CONTROL
(4-pin CPU_FAN1)
(see p.1, No. 2)
ATX Power Connector
(24-pin ATXPWR1)
(see p.1, No. 4)
manuals search engine
This header is for
GND
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
Please connect fan cables
GND
to the fan connector and
FAN_VOLTAGE_CONTROL
FAN_SPEED
match the black wire to
FAN_SPEED_CONTROL
the ground pin.
This motherboard pro-
FAN_SPEED
vides a 4-Pin CPU fan
FAN_SPEED_CONTROL
GND
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
This motherboard pro-
12
24
vides a 24-pin ATX power
connector. To use a 20-pin
ATX power supply, please
plug it along Pin 1 and Pin
1
13
13.
Werbung
Inhaltsverzeichnis
