Lighting Technologies SKYLINE LED 120 Montageanleitung Seite 9

5.1. Tools needed
5.2. Place wire bracket(1) on the luminaire and fix it with screw (2) with washer (3) and block (4)
(leave the screw a bit loose).
5.3. Hang the luminaire onto wire.
Cable diameter - 12 mm. Place clamping plates (5) on the bracket (1) with screws (6), lock
washers (7) and plain washers (8) locking the luminaire on the wire. Screws' (6) tightening torque –
at least 5 Nm.
5.4. Align luminaire position if needed. Tighten screw (2) with at least 20 Nm of torque.
6. Installation on suspended support
6.1. Tools to be used and suspended support requirements
9