Lighting Technologies SKYLINE LED 120 Montageanleitung Seite 10

6.2. Screw adapter (1) into luminaire flange (2) having previously put luminaire's cable through it.
(IMPORTANT! This operation should be done before connecting mains cable to luminaires'
terminals).
6.3. Set the luminaire on suspended support. Align holes in the pole and adapter, put pin (3)
through them and lock it with cotter pin (4).
6.4. Set desired luminaire position and lock it by scerw (5), tightening torque at least 5 Nm.
6.5. IMPORTANT! When installing LORA luminaries, LORA controller should be placed into
appropriate connector on luminaire's body
6.6. IMPORTANT! When mounting PLC luminaries the PLC device serial numbers (included
stickers with s/n), should be placed on each stand which luminaries are mounted on.
Recommended height of placing the stickers – 1.8-2 m. It is necessary for proper conducting of
commissioning works following.
6.7. ATTENTION!LIFTING AND CARRYING THE LUMINAIRE BY THE CABLE IS NOT ALLOWED
in order to avoid damage to cable, sealing and internal circuits of the luminaire
These instructions assume expert knowledge corresponding to a completed professional
education as an electrician.
10