Bearing Installation - 3TECH TURBINE TR-720L Benutzerhandbuch

Bearing detachment
If the ball bearing is damaged but it's outer ring hasn't dropped off , put the "bearing outer ring detach tool" between the
bearing and the rotor. Put the screw bolt outside, then rotate the screw bolt of tool clockwise until the inner ring is removed.
If the ball bearing is damaged and it's outer ring has dropped off , insert the notch of the "bearing outer ring detach tool" at
the inner ring path of ball bearing, then rotate the screw bolt of tool clockwise until the inner ring is removed.

Bearing installation

When pre-installing the bearing, please insert the bearing on the shaft fi rst, with the dustproof shield facing outside, then
put it on the bearing installation tool. Knock at the upper side of inner ring of bearing gently with the push axle, ensure the
bearing is placed in the middle. Then press the head of push shaft in order to make the bearing is closed to the turbine.
Note: the "bearing outer ring detach tool" and "bearing installation tool" are not supplied. Please contact supplier if the
tools are required. Equipment can only be repaired by the manufacturer or authorised agent.
20
Fig. 6.1
Fig. 6.2
App
F
Usa
Fig. 6.1
Replac
–
–
–
Install
–
No
Fig. 6.2