Setting The Alarm - Clatronic MRC 498 DT Bedienungsanleitung, Garantie

44083-05-MRC 498 DT
4. When the TIME button is pressed again, it is possible to set the month and the
GB
date. The weekday changes automatically when the date is altered.
The time can be displayed according to the 12 hour or 24 hour system.
To change from one system to the other, press the +/12/24 hour button.
If no button is pressed within 15 seconds, the machine automatically switches
back to the normal time display.
An integrated sensor reads the temperature and displays it in the bottom right-hand
corner of the display. This can be changed from Celsius (°C) to Fahrenheit (°F) by
pressing the -/°C/°F TEMP button (12).
1. Press the ALARM button until the display begins to flash.
2. Then press the +/12/24 hour button (11) in order to go forwards or the -/°C/°F
TEMP button (12) in order to go backwards until the desired hour has been rea-
ched.
3. Press the ALARM button again. The minutes now begin to flash. Proceed as
described above in item 2.
In order to activate the alarm, move the function button (8) to the AUTO position. An
LED lights up in the display. If you would like to be woken up by a buzzer, move the
RADIO/ON/OFF/AUTO button (8) to the middle position. Press the ON/OFF button
(7) in order to activate the alarm.
When the alarm is activated, an alarm clock symbol appears in the display in the
top left-hand corner. In order to switch off the alarm, press the ON/OFF button. The
symbol in the top left-hand corner of the display disappears.
The alarm can be switched off for approximately 5 minutes with the snooze button.
After approximately 1 hour the alarm switches off completely until the following day.
Always remove the mains plug before cleaning the device.
Clean the machine with a slightly damp cloth without any additives.
Do not immerse the machine in water.
Please do not throw old batteries in the domestic waste, but return them to a suita-
ble location for environmentally-friendly disposal.
10
Downloaded from www.Manualslib.com
03.12.2002 15:49 Uhr

Setting the Alarm

Automatic Interval Alarm
manuals search engine
Cleaning
Seite 10