Setting The Time; General Operation - Clatronic MRC 7007 Bedienungsanleitung

Inserting the Reserve Batteries
(Batteries are not Included in the Scope of Delivery)
In case of power failure or if the power supply unit is pulled from the plug, the settings
are maintained if the reserve batteries are inserted.
1. Open the battery compartment lid on the back.
2. Insert two type AAA / R 03 1.5 V batteries. Check that the polarity is correct (see
battery compartment).
3. Close the battery compartment.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. Danger of explosion!
CAUTION:
• Batteries can leak battery acid. If the device is out of use for a long period of
time, remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Batteries are not to be disposed of together with domestic wastes. Dispose of
the used batteries at the relevant collection bin or at your dealer's.
1. Switch the device off.
2. Keep the SET / PRE / M + button pressed for a short time. The time indicator
begins to flash.
3. Set the hours with the HOUR / TU– button and the minutes with the MIN / TU+
button.
NOTE:
If you do not press a button within 4 seconds, the settings are automatically
accepted.
Switch Device On / Off
• Use the ON / OFF button to switch the device from standby to operating mode.
The dot next to "FM" lights up in radio mode.
• To disconnect the device completely from the mains, pull the mains plug from the
socket.
MRC7007_CTC_IM

Setting the Time

General Operation

35
12.10.17