Maintenance And Disposal - FALMEC Bellaria Gebrauchsanweisung

EN

Maintenance and disposal

MAINTENANCE
Before carrying out any cleaning or maintenance
operations, disconnect from the power supply.
Do not use detergents containing abrasive, acidic or
corrosive substances or abrasive cloths.
Regular maintenance guarantees proper operation and perfor-
mance over time.
Particular attention should be paid to the dust filter and honey-
comb carbon filter: cleaning the filters frequently reduces depos-
its of dust or other particulate matter.
CLEANING OF EXTERNAL SURFACES
It is recommended to clean the exterior surfaces of the BELLARIA
periodically: clean using a damp cloth slightly dampened with
mild liquid detergent or denatured alcohol. Finish off cleaning by
rinsing well and drying with soft cloths.
Do not use too much water next to the push button
control panel and lighting devices in order to prevent
humidity from reaching electronic parts.
The glass can only be cleaned with specific, non-corrosive or
non-abrasive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply
with these instructions.
CLEANING OF INTERNAL SURFACES
It is forbidden to clean electrical parts, or parts related
to the motor or ioniser, with liquids or solvents.
For the internal metal parts, see the previous paragraph.
DUST FILTERS
For this reason it is recommended to
clean the filter frequently (at least eve-
ry month) using compressed air or by
washing in a basin with warm water and
a mild detergent.
Rinse it well and wait for it to be com-
pletely dry before reassembling.
HONEYCOMB CARBON FILTER HP
The HONEYCOMB carbon filter is in-
tended to retain odours found in the air
flow passing through it:
With normal use, we recommend re-
storing the filter every 36 months and
replacing it after 9 years. To restore it,
simply put it into an ordinary domestic
oven set at 200°C for about 2 hours.
Wait for the filter to cool before reassembling it.
The honeycomb carbon filter cannot be washed.
The honeycomb carbon filter is held in place by two
magnets placed inside the device: pull gently to remove
it.
Dispose of the honeycomb carbon filters in compliance with the
regulations in force in the Country of use.
IONISER
The maintenance of the ioniser cannot
be performed directly.
You can vacuum through the grating
to remove the dust or other particulate
matter that settles over time.
The ioniser is equipped with a blue LED to indicate operation.
With BELLARIA working:
blue LED on: ioniser working.
blue LED off: the ioniser is broken or not connected properly. In
this case contact the dealer or authorised service centre.
13
Bellaria