English; Introduction; Technical Data Buggy 10; Assembly - Hamach BUGGY 10 Gebrauchsanleitung

English

Introduction

We congratulate you with purchasing this Hamach tin press and thank you for your trust. This press
can be used for reducing the volume of empty tins up to 85 %. The Buggy 10 can be used for tins up
to 10 L. Please read the manual carefully. E.M.M. International BV does not accept responsibility for
inaccurate use of the Buggy 10.

Technical data Buggy 10

Height :
Depth: :
Width: :
Size incl. frame :
Air connection :
Air pressure :
Working pressure :
Presstime :
Pressure :
Weight :
Weight incl. frame :
Air consumption :

Assembly

The Buggy 10 is standard delivered without a mounting frame and can be used on a fixed table or
similar object (frame Buggy 10: art. no. 000842). The press should be bolted to the surface it is placed
on. The press should be connected to an oil free air conduit. The Buggy 10 has a self service pressure
cylinder, which makes greasing obsolete.
The Buggy 10 is equipped with:
• Pressure regulator
Manometer
•
Water separator
•

First use

The air conduit should not provide a higher pressure than 10 bar. The recommended air pressure for
the Buggy 10 is 6 bar. When the pressure is set differently, then you need to reset it to 6 bar.
After opening the door of the press you can place empty tins, after being cleaned, in the
•
press. It is possible to press multiple small tins at once. Make sure that the tins are
symmetrically placed in this case. This prevents uneven wear of the cylinder and mechanical
parts.
• Close the door of the Buggy 10 (84126). Push the pressure switch (084120). After pressing
the tins the pressing plate remains in its upper position.
When the door is opened, the plate is on the upper position and leaves room for you to
•
remove the pressed tins.
When the compressed airline is removed, the press plate will go back in the lower position. In this
position the door cannot be opened. As soon as the compressed airline is reconnected you can open
the door. This safety circuit is prescribed in the European Machine Directives for Pneumatic Presses.
The Safety System of the Press makes it impossible to open the door during pressing. Don't try to
force it. You have to wait until the complete pressing is finished.
Attention! Only completely empty tins can be pressed.

Cleaning

Paint remnants in the Buggy 10 should be removed immediately. This can negatively effect the
functioning of the tin press.
Attention! When cleaning the Buggy 10, the pressure on the press should be connected.
104 cm
35 cm
33 cm
158 x 50 x 36 cm
¼ G
max. 10 bar
6 bar
3s /6 bar
450 kg by 6 bar
36 kg
40.5 kg
20 l/pressure
9