Blaupunkt ATF501 Bedienungsanleitung Seite 7

ATF501
1. Front fan grille
2. Fan blade nut
3. Fan blade
4. Back grille fixing nut
5. Back grille
6. Motor shaft stem
APPLIANCE ASSEMBLY AND DISASSEMBLY
1. Make sure the appliance is disconnected from the power source.
2. Assembly:
a) Place the motor body (7) in the base (11).
b) Put the back grille (5) on the motor base (pay attention to the notches).
c) Screw on the back grille fixing nut (4).
d) Put on the fan blade (3) paying attention to the notch in the stem (6) and the fan blade opening.
f ) Tighten the fan blade fixing nut (2)
g) Install the fan's front grille (1) by fitting the edge into the hooks on the back grille. Then secure by
tightening the grille's fixing screw (9).
3. Disassembly:
a) Perform the disassembly in the reverse order of the assembly procedure.
FAN OPERATION
1. Before connecting the fan to the power supply, make sure that the button on the control panel is set
to 0. Connect the appliance to the power supply.
2. To start the fan, press one of the buttons on the control panel:
1 - low speed
2 - medium speed
3 - high speed
3. To turn off the fan, press the 0 button on the control panel.
4. Oscillation. To enable the fan's oscillation movement, press the oscillation lock. To disable the fan's
oscillation movement, lift the oscillation lock.
5. Vertical tilt adjustment. To change the fan tilt, hold the appliance in position and tilt the motor body.
CLEANING AND MAINTENANCE
Before cleaning and maintenance, make sure that the fan has been disconnected from the power
source.
The fan should be cleaned regularly. Body, posture should be wiped with a dry cloth. The interior
should be blown out with compressed air or vacuumed with a vacuum cleaner.
7. Motor housing
8. Oscillation lock
9. Grille fixing screw
10. Control panel with buttons
11. Base
5