Tally Genicom 9045N Kurzanleitung Seite 26

Chapter 2 Setting Up Your Printer
22
14 The control Panel shows again "Subnet
Mask".
15 Press NEXT and "Default Gateway" is
shown on the display.
16 Repeat steps 7 – 10.
17 The control Panel shows again "Default
Gateway".
18 Press START/STOP button to finish.
Print a configuration summery to check the proper setting of the IP Address, Subnet Mask and
Default Gateway.
Quick Start Guide
Network 1 Setup
Subnet Mask
Network 1 Setup
Default Gateway
Network 1 Setup
Default Gateway