Tally Genicom 9045N Kurzanleitung Seite 25

Quick Start Guide
Use the following procedure to enter the interface menu and add the IP Address
and other related settings.
1 Press the MENU button on the control panel.
2 Press the NEXT button until the text
3 Press the SELECT button to enter the interface menu.
4 Press NEXT until the text "Network 1
5 Press SELECT.
6 Press NEXT until "IP ADDRESS" is
7 Press SELECT.
8 Use NEXT/PREVIOUS buttons to change the digit.
9 Press SELECT for the next digit.
10 Press SELECT after all digits are set.
11 The control Panel shows again "IP
12 Press NEXT and "Subnet Mask" is shown
13 Repeat steps 7 – 10.
"Interface Menu" is shown on the second
line of the display.
Setup" is shown on the display.
shown on the display.
Address".
on the display.
Chapter 2 Setting Up Your Printer
Menu
Interface Menu
Interface Menu
Network 1 Setup
Network 1 Setup
IP Address
Network 1 Setup
IP Address
Network 1 Setup
Subnet Mask
21