Preparation; Filter Installation; Operation; Start/Stop - Sharp UA-HG40E-L Bedienungsanleitung

PREPARATION

FILTER INSTALLATION

1 Remove the Back Panel.
2 Remove the plastic bag from the each
fi lter.
HEPA Filter

OPERATION

START/STOP

START

CLEAN ION SHOWER MODE

The unit releases Plasmacluster ions with strong airfl ow and
collects dusts while decreasing static electricity for 10 min-
utes. After that, the DUST sensor sensitivity is automatically
set to "HIGH"and quickly detects impurities
and clean the air powerfully for 50 minutes.
Back Panel
Deodorizing Filter
STOP
NOTE
• When the operation fi nishes after
60 minutes, the unit will return
to the prior operation mode. It is
able to change the other mode
during this mode.
• The Plasmacluster Ion can not
be turned "OFF". (Ref. E-10)
Always be sure to remove the
power plug from the wall outlet.
3 Install the fi lters in the correct order as
shown.
4 Install the Back Panel.
3
NOTE
• When replacing the fi lter, making a memo of the start of
use date is recommended.
INTELLIGENT MODE
The fan speed is automatically controlled depending on the 7
detection. (Ref. E-1)
AUTO MODE
The fan speed is automatically controlled depending on the
5 detection. (PM2.5 / Usual dust / Temperature /Humidity /
Light)
NOTE
• Front Display, Cleanliness Monitor and Air Outlet LED
automatically switch ON and OFF based on room
brightness. (When light control is set to "Auto". Ref. E-11)
E-7
HEPA Filter
Tag
Deodorizing Filter
Click
2
3
(UA-HG60E / UA-HG50E)
(UA-HG40E)
1