Using The Product - nedis RDFM3100YW Kurzanleitung

- WARNING
•
Ensure you have fully read and understood the
instructions in this document before you install
or use the product. Keep this document for
future reference.
• Only use the product as described in this manual.
•
Only use the provided power cable.
•
This product may only be serviced by a qualified
technician for maintenance to reduce the risk of
electric shock.
•
Disconnect the product from the electrical outlet
and other equipment if problems occur.
• Do not drop the product and avoid bumping.
• Do not expose the product to water or moisture.
• Do not use the product near water.
•
Do not expose the product to direct sunlight,
naked flames or heat.
•
Children should be supervised to ensure that
they do not play with the product.
• Battery usage by children should be supervised.
• Batteries contain explosive gases. Prevent
exposure to flames and sparks.
• Don't leave the battery in an environment with
extremely high temperatures.
•
Don't expose the battery to an environment with
extremely low air pressure.
•
There is a risk of explosion when the battery is
replaced by an incorrect type.
• Avoid replacing the battery with an incorrect
type.
• Don't dispose the battery in a fire or hot oven, or
by mechanically crushing or cutting the battery.
•
Remove the batteries if you do not use the
product for an extended period of time.
•
Unplug the product if you do not plan on using
the product for an extended period of time.
• When the product is not used for an extended
period, store the product in a dry place away
from sunlight and protect it against excessive
dust and dirt.
•
Do not open the product. There are no user
serviceable parts inside.
•
Do not put hands and foreign objects inside the
product.
•
Keep the product away from magnetic or
magnetized objects.
RDFM3100YW_MAN_EN_0520_print_(20066 1422)_v00_03.indd 5 RDFM3100YW_MAN_EN_0520_print_(20066 1422)_v00_03.indd 5
•
Do not use the product if a part is damaged or
defective. Replace a damaged or defective
product immediately.
• Make sure that the power cable cannot become
entangled and does not hang over the edge of a
worktop.
•
Listening on high volume for a long time will
damage your hearing.
•
Do not block ventilation openings and make sure
that there is enough space around the product.
Setup
4 Choose between setup option A or B.
A. Connecting the product to a power source
The mains plug is used as the disconnect device,
-
such disconnect device shall remain readily
operable.
1. Open the dust cover A
2. Connect the power supply A
u
supply port A
.
3. Connect the other end of A
B. Inserting the batteries
Make sure to match the (+) and (-) polarity
-
markings.
1. Open the battery compartment lid A
2. Insert 6 type C batteries (not included) in the
battery compartment A
y
3. Close A
.

Using the product

1. Press the power button A
product.
2. Rotate the volume wheel A
volume to the desired sound level.
3. Press the source button A
the input sources (Bluetooth, FM radio or AUX).
6
4. Press and hold A
to switch off the product.
4
The product automatically switches to energy-
saving mode after 15 minutes inactive. Press
8
A to activate the product again.
Connecting to AUX
1. Open the AUX compartment lid A
2. Connect your audio source to the AUX IN
q
compartment A
.
w
3. Close A
.
5
i
.
o
to the power
o
to a power outlet.
y
.
t
.
6
to switch on the
9
to adjust the
8
to cycle between
w
.
02-06-2020 15:18 02-06-2020 15:18