Cleaning And Storage - MAXXMEE KLP-B025 Bedienungsanleitung

EN

CLEANING AND STORAGE

Please Note!
■
No liquid must get into the device
(with the exception of the water tray
and the water tank). Never immerse
the device in water!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Make sure that the device is not con-
nected to the mains power.
• Wipe down the device with a soft,
damp cloth. Remove more stubborn
dirt with a little mild detergent.
• Keep the device operational and
clean the honeycomb fi lters (4) if
necessary.
• If the device is not going to be used
for a prolonged period and before
storing it away, it is essential to
remove any remaining water from the
water tank (10).
• Store the device in a clean, dry place
so that it is protected and is out of the
reach of children and animals when it
is not in use.
Cleaning the Honeycomb Filters
Please Note!
■
When rinsing the honeycomb fi lter,
the water pressure must not be too
great and the jet of water must not
be too strong. This could damage the
honeycomb fi lter.
■
Do not use any acidic or alkaline
cleaning agents.
1. Undo the screws on the honeycomb
fi lter covers (5) and take them off.
2. Grab a honeycomb fi lter cover on
both sides at the top edge, press
18
against the housing (13) with your
thumbs and thus release the honey-
comb fi lter cover from the housing.
You need to apply a little force to do
this.
3. Lift the honeycomb fi lter cover up out
of the housing at an angle.
4. Tilt the honeycomb fi lter (4) towards
you at the top and lift it up out of the
device at an angle (Picture E).
5. Repeat steps 2 to 4 for the remaining
three honeycomb fi lters.
6. Rinse the honeycomb fi lters under
running water.
7. Allow the honeycomb fi lters to dry
completely.
8. Insert the honeycomb fi lters into the
device.
9. Place the honeycomb fi lter covers in
the housing and press them against
the housing by their top edges.
When you do this, make sure that
the locking lugs at the bottom of the
honeycomb fi lter cover fi t in the corre-
sponding recesses in the housing.
10. Fix the honeycomb fi lter covers in
place with the screws.
Emptying the Water Tank
There are two possible ways to empty the
water tank (10):
Drain Plug
Pull out the drain plug (7) on the bottom
of the water tank and allow the water to
drain away.
Dismantling
Detach the water tank from the hous-
ing (13) (see the "Filling the Water Tank"
chapter – "Alternative Filling") and pour
away the rest of the water.