15.1
Bring the metal belt in the vertical position and open the bandsaw blade cover.
Loosen the saw blade with the adjustment knob (2).
Saw blade guards above (red) and at bottom remove.
Now pull down the old blade. DANGER! Injury! Wear work
gloves.
The new bandsaw first insert the blade
WARNING: Respect the right direction of the
image
Then put on the wheels.
Set the saw blade with the adjustment knob (2) tension (1
mm test). After making a short test run and retighten if
necessary.
Saw blade guards above (red) and bottom screw on.
Screw the saw band cover back.
15.2
The impeller is factory aligned to the drive wheel. Should, however (especially after exchange) of
the saw blade is not straight or run from the impeller, an adjustment may be necessary.
The tape / camber can be adjusted.
The clamping screw slightly loose.
With the grub screw the tape can be adjusted.
Tighten the clamping screw.
HOLZMANN Maschinen GmbH
Downloaded from
www.Manualslib.com
Changing the saw blade
left front of the saw
arm)
Setting tape / camber
clamping screw
www.holzmann-maschinen.at
manuals search engine
guides.
teeth. (see
grub screw
MAINTENANCE AND CARE
Saw blade guard
Seite 42
BS 115