Electrical Connection; Earthing Connection - Holzmann BS 115 Betriebsanleitung

13.1.3 Electrical connection

Only a qualified electrician is authorized for the electrical connection, including the installation of
the supply part. This must be cut off before the electrical connection. Only when the main power
supply is cut off, each contact can be closed. The cowl box is attached to the back of the machine
body. There is also a junction box on the side, which you have to connect only to the marking.

13.1.4 Earthing connection

 The electrical connection of the machine is ready for operation on a grounded electrical outlet!
 The plug must be connected only to a properly fitted and grounded electrical outlet!
 The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
 The grounding conductor is green-yellow!
 In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
 Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
 A damaged cable must be replaced immediately!
HOLZMANN Maschinen GmbH
Downloaded from www.Manualslib.com
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
www.holzmann-maschinen.at
manuals search engine
A T T E N T I O N
Assembly
Seite 34
BS 115