14.2.3 Band saw operate vertical
Raise the arm band saw in the 90 ° position and clamp
it on the base console with the fixing bracket.
Remove the protective cover.
The work talbe with the two screws attach on the
bandsaw blade guide.
Loosen the fixing screw at the bandsaw blade guide.
Insert the support bracket by the fixing screw
Screw on the table top with the countersunk screw up
and the washer and nut below.
The top bandsaw blade guide by unscrewing the fixing
nut (12) and screw into the threaded hole 2. be
pushed deeper.
As a result, the bandsaw blade is made even better.
HOLZMANN Maschinen GmbH
Downloaded from
www.Manualslib.com
protective cover
www.holzmann-maschinen.at
manuals search engine
OPERATION
Work table for
vertical sections
support bracket
fixing screw
Seite 40
BS 115