Garant mLevel Bedienungsanleitung Seite 21

Downloaded from www.Manualslib.com
Code Cause
A 102 Two-hand opera-
tion, block
A 103 Two-hand opera-
tion, button missing
A 111 Travel monitoring
A 112 Hall sensor,
no signal
A 113 Hall sensor, wrong
direction of rotation
of the motor
A 114 Motor missing, no
connection
A 115 Motor missing, no
power
A 201 Continuous running
time, block
A 202 Overheating
A 215 Drive overcurrent
manuals search engine
Troubleshooting
A second manual switch with only a single
button is connected to the control system. To
enable movement, you must press this button
at the same time as you press the UP 1 or
DOWN 1 button.
The control system is configured for operation
with an manual enable switch (two-hand
operation), however the manual enable
switch is not connected or is defective.
Either connect the manual enable switch or
exchange it.
The control system has detected an
error during movement of the bench. The
bench may be jammed or overloaded, or a
motor is not correctly connected to the con-
trol system. Rectify the fault and then move
the bench briefly in the opposite
direction.
System overload! Disconnect the device from
the mains. If the same error message is still
reported after 10 hours, contact your
customer service.
The drives have been running longer than
is permissible. To protect the control system
from overheating, operation will then be
blocked for a few minutes.
After expiry of the protection period the
drives can once again be operated.
System overload! Disconnect the device from
the mains. If the same error message is still
reported after 10 hours, contact your custom-
er service.
www.hoffmann-group.com
DE
DE
EN
FR FR
IT
IT
ES
ES
21