First Time Installation - Sharp HT-SB140 Bedienungsanleitung

1.
2.
3.
4.
5.
6.
7.

First time installation

Remote control preparation
The provided Remote Control allows the
unit to be operated from a distance.
• Even if the Remote Control is operated
within the eff ective range 6m, remote
control operation may be impossible
if there are any obstacles between the
unit and the remote control.
• If the Remote Control is operated near
other products which generate infrared
rays, or if other remote control devices
using infra-red rays are used near the
unit, it may operate incorrectly. Conver-
sely, the other products may operate
incorrectly.
FIRST-TIME USE: The unit has a
pre-installed lithium CR2025 battery.
Remove the protective tab to activate
the remote control battery.
Downloaded from www.Manualslib.com
– Switch the unit between ON and
STANDBY mode.
MUTE – Mute or resume the sound.
Function buttons – Select the play
function.
VOL+/VOL- – Increase/decrease the
volume level.
/ – Skip to previous/next track in
Bluetooth mode.
/ PAIR – Play/pause/resume
playback in Bluetooth mode.
Press and hold to activate the
pairing function in Bluetooth mode
or disconnect the existing paired
Bluetooth device.
EQ buttons – Select a preset sound
mode.
manuals search engine
Remote control battery
replacement
2
1
4
The remote control requires a CR2025, 3V
Lithium battery.
1. Push the tab on the side of the battery
tray towards the tray.
2. Now slide the battery tray out of the
remote control.
3. Remove the old battery. Place a new
CR2025 battery into the battery tray
with the correct polarity (+/-) as
indicated.
4. Slide the battery tray back into the slot
in the remote control.
Placement and Mounting
A
A: Normal Placement (place Soundbar on
leveled surface in front of TV)
B: Wall Mounting
EN
3
B