INFICON D-TEK 3 Kurzanleitung Seite 4

NOTE: There is no sensitivity setting in Manual Zero mode.
Removing and installing the lithium ion battery
1
Press the eject button to release the battery door.
2 Move the battery release tab to the side until the battery begins to eject.
3
Slide the battery out.
4
Align the new battery with the rails.
5
Gently push the battery along the rails until the battery release tab engages.
ð Do not force the battery. If it does not slide freely, check alignment and try
again.
6
Reinstall the battery door.
Replacing and installing the sensor
1
Press the eject button to release the battery door.
2 Grasp the sensor release tab and gently pull the sensor out.
4 / 68
eject button
battery release tab
eject button
sensor release
tab