PEDROLLO DG PED 3 Bedienungsanleitung Seite 25

Unscrew and remove the filling plug and the vent plug.
Pour in about 1.5 litres of water until it pours out of the
vent hole.
Rescrew the filling plug and the vent plug.
Open the water tap
SIMULTANEOUSLY press buttons
DG PED enters into a priming mode.
RED LED
FIXED
The priming procedure lasts at most 5 minutes, at the end of each minute DG PED automatically stops the electric pump
for five seconds then immediately restarts it. This is repeated for all the time the DG PED is priming. During this procedure
the LEDS will continue to flash.
The exit from the priming procedure can occur either because of time out (5 minutes) or because it is completed. The
LEDS stop flashing. If the pump does not prime repeat the operation from the start.
and for 5 seconds.
GREEN LEDS
FLASHING
GREEN LED
FLASHING
Attach the plug to the electricity supply.
Turn the switch to "I".
Press button to start priming.
GREEN LEDS
FLASHING
ENGLISH | 25