Vacuum Packing Process Description - Hendi 975251 Handbuch

4. If the machine was kept in a cold place (below
5°C), leave it for approx. 1 hour before starting.
5. Connect the power cable to the mains.
INSTALLATION
7. Before starting the machine up, please read the
information on operation and safety included in
the manual.
8. Make sure that the oil level is at least at 1/2 or 1/3
of window height. When the appliance is working,
the oil level should not drop below 1/3 of the win-
dow height. Do not overfi ll the machine as the oil
may overfl ow.
CONSUMABLES
• Oil - oil for the vacuum pump should be replaced
at least once every 6 months. We recommend Vic-
tor Vacuum Oil available for purchase from the
manufacturer or distributor.

4. VACUUM PACKING PROCESS DESCRIPTION

1. Connect the machine to power source.
2. Flip the blue switch at the back of the machine
upwards.
3. Turn the machine using the "ON" button - "- -"
will light up on TIME(S) display. (for a dozen or so
seconds up to a few minutes). Changing of set-
6. Set the on/off switch (blue switch at the back of
the machine) to ON position (switch raised - ma-
chine is ON).
9. Place the machine in a vertical position in a well
ventilated and well lit room, without access of
any toxic gases or dust.
10. Make sure the machine is grounded.
11. Before turning the power on always check if the
top cover is open.
• Tefl on bar - Replace when burnt. Failure to do
so may cause damage to the sealing bar. Tefl on
bars may be purchased from the manufacturer or
distributor.
tings will be impossible then.
4. Press SET button (parameter selection) - "VACUUM"
LED will light up. Set the desired vacuum value by
pressing "+" button to increase or "-" to decrease
vacuum level. Time range is 0-99 seconds. The
result will shown on TIME(S) display.
EN
7