Maintenance - Plastimo 3000 RANGE Installationsanleitung

COOKER ACCESSORIES (SUPPLIED ACCORDING TO MODEL)
Pan Support - The pan support is located in 4 holes on the main hob. The pan support is
hooked into the rear holes and then sprung into place at the front edge to prevent rattling.
Oven Shelf - To fit an oven shelf, place the shelf do that the hooks are to the back of the
cooker, ensuring that they pass under the oven shelf runners and lift the notches above the
runners. If the shelf is correctly fitted it will not tip when pulled forward. (FIG 8)
Door Catch - Certain cookers are fitted with a wire door catch which is sprung into holes in
the sides of the cooker and dropped down over the door. The same catch can be used as a
grill pan stop by fixing the wire in the upper pair of holes.
Gimbal Lock - On models fiited with a gimabl lock below the oven door the gimbal plate
should be fixed to the bulkhead such that when the cooker is locked the hob top is level.
Baking Tray
Grill Pan and Trivet
Feet - Used to fix the unit in place. See the installation instructions at the front of the
booklet.
CLEANING
1. Each time the hob has been used it should be wiped over with a damp cloth and if
greasy a little mild liquid cleaner.
2. Stubborn marks can generally be removed with one of the commercial cleaners. Do not
use harsh abrasive materials as these will leave scratch marks.
3. The interior of the oven should be cleaned with a damp cloth but if it becomes necessary
to use a cleaner then choose an appropriate enamel cleaner.
4. All spillages should be wiped up immediately before they "burn on".
We recommend that you occasionally remove the enamelled tops to your burners and clean
them ensuring the ports in the top are free from dirt and grease.
If properly adhered to, these few simple suggestions should extend the life of your cooker.

MAINTENANCE

Before attempting any maintenance work make sure that the gas supply is turned off at the
cylinder and disconnected from the unit. If the spillage tray is removed care must be taken to
ensure that the gas joints are not stressed as this may result in a gas leak. NO GAS JOINT
SHOULD BE BROKEN.
To Remove a Spillage Tray
v
Remove the pan support grid.
v
Unscrew the 4 pan support screws.
v
Release the socket screw on the side of each burner and remove the enamel cap.
v
The spillage tray can then be lifted clear.
To Replace a Hob Thermocouple
v
Remove the spillage tray as explained above.
v
Release the thermocouple from the back of the tap.
v
Release the nut holding the thermocouple into the burner.
v
The new thermocouple can then be bent to shape and the process reversed.
To Replace a Grill Thermocouple
v
Remove the spillage tray as explained above.
v
Release the thermocouple from the rear of the tap.
v
Disconnect the probe from the grill hood inside the grill compartment and remove.
v
Fit the new thermocouple ensuring the tip of the probe is in line or slightly above the holes in the
grill tube and no further than 4 mm away.